Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Projects is switched off
Projects, the schedule, planning, the work plan and the Lab. This demo has the Projects module switched off in Organisation settings.
Build sheetBatch 6 of 7Project PRJ-09Simulated live
2.03 Curlew av extender 2
Every value recorded · 3 settings to set, 11 to checkchecked just now
Asset register
Assetbox › Assets- Asset tagAssetbox › Assets
The install recordAG-001321CheckThis unitAccepted - Serial numberAssetbox › Assets
The install recordDEMO-LON-001321CheckThis unitAccepted - ModelAssetbox › Assets
The space typeKramer EXT3-C-XR-TCheckEvery unitAccepted - LocationAssetbox › Assets
The spaceLondon office, 2.03 CurlewSetThis unitAccepted
DIP-switches - EXT3-C-XR-T (transmitter)
Rear panel SETUP DIP-switches- ETH by USB (DIP 1A)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 1A
The setup guide, the same on every unitOff (ETH enabled)CheckEvery unitConfirmed - HDBT Range Mode (DIP 2A)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 2A
The setup guide, the same on every unitOff (Standard range mode)CheckEvery unitConfirmed - Active USB Host (DIP 2B)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 2B
The setup guide, the same on every unitOff (this unit is the active USB host)CheckEvery unitConfirmed - IR Modulation (DIP 3B)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 3B
The setup guide, the same on every unitOff (IR pass-thru enabled)CheckEvery unitConfirmed - RS-232 operation Mode (DIP 4B)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 4B
The setup guide, the same on every unitOff (RS-232 firmware programming inactive)CheckEvery unitConfirmed
DIP-switches - EXT3-POE-XR-R (receiver)
Rear panel SETUP DIP-switches- HDBT Range Mode (DIP 1A)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 1A
The setup guide, the same on every unitOff (Standard range mode)CheckEvery unitConfirmed - Active USB Host (DIP 2B)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 2B
The setup guide, the same on every unitOn (this unit's USB is a slave)SetEvery unitConfirmed - IR Modulation (DIP 3B)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 3B
The setup guide, the same on every unitOff (IR pass-thru enabled)CheckEvery unitConfirmed - RS-232 operation Mode (DIP 4B)Rear panel SETUP DIP-switches › Rear panel › SETUP DIP-switches › 4B
The setup guide, the same on every unitOff (RS-232 firmware programming inactive)CheckEvery unitConfirmed
Power
Rear panel- Power sourceRear panel
The setup guide, the same on every unitEXT3-C-XR-T's own 20V adapter, run to the table endSetEvery unitConfirmed
No setting matches these filters.