Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Projects is switched off
Projects, the schedule, planning, the work plan and the Lab. This demo has the Projects module switched off in Organisation settings.
Batch 10 of 16 · Project PRJ-22Simulated live
4 Kramer Galil 6-C loudspeakers
0 of 4 units set up · nothing to reviewchecked just now
Setup is done by Aigna's engineers. Your installs are on the Deploy page.
Once for all 4
Through Rear-panel tap selector (physicalSet on each unit by hand Rear-panel tap selector (physical. Keia Atlas cannot read these back, so a person confirms them.
1 settings to set and 0 to check; 0 left at the manufacturer's default.See every settingThe setup guide
The same on every unit
- Transformer tap
- 100V, 15W (paired with a PA-240Z set to Hi-Z/100V)
The units
Only what differs per unit. Each unit's build sheet has every setting worked out.Nothing is ready for you here. Keia Atlas keeps checking these units.
| Unit | Provision | Install | Configure | |
|---|---|---|---|---|
| Build sheet | ||||
| Build sheet | ||||
| Build sheet | ||||
| Build sheet | ||||
Setup order
Optional: tick as you go, or let the checks do it1Cut the ceiling opening to the 224mm cutout diameter and fit the speaker, checking clearance for the 196mm mounting depth above the ceiling.0/4
2Wire the 4-pin terminal block to the amplifier's Hi-Z output (pins 1/2 are +, pins 3/4 are -, so a second pair can loop to the next speaker).0/4
3Set the tap selector behind the grille to match the amplifier's output mode and the space's desired loudness before fitting the grille.0/4
4Fit the grille and confirm audio reaches the speaker at the expected level.0/4
Every setting
1 in the setup guide, as patternsValues marked Per unit are patterns here. Each unit's build sheet has them worked out: 3.03 Heron, 3.03 Heron, 3.03 Heron, 3.03 Heron.
Tap selector1
- Transformer tapPer unitRear tap selector (Figure 7: Adjust Tap Selector)Set to 100V, 15W (paired with a PA-240Z set to Hi-Z/100V)Worked out on each build sheet
Why
The manual states no factory-default tap position, so it must be set to match the amplifier's 100V output and the wattage the space actually needs; too high a tap wastes amplifier headroom, too low risks clipping.