Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Assets is switched off
Device types, units, models, setup guides, standards, IT stores and cables. This demo has the Assets module switched off in Organisation settings.
Setup guideAV extenderStand-aloneSimulated
TP-580Rxr receiver
Every unit in use matches itchecked just now
Configuring happens in a project's Deploy page
Each device is provisioned, installed, configured in this setup order and commissioned there, ticked off with who and when. This page is the standard it follows.
No project is configuring it now. Every project
On the units running it
- Units in service
- 4
- Records drifted
- None
A practice run. A new install, in order. Ticks stay on this browser. The real run is ticked device by device in a project's Deploy page.
0 of 6A compact fan-less HDBaseT receiver with a single range/quality slide switch. The manual gives no factory default for that switch, so it's the one thing every install must set deliberately.
Front panelRear panel slide switch
- SetNORMAL/XTRA RANGE Slide SwitchRear panel › NORMAL/XTRA RANGE slide switchNORMAL (up to 100m at 1080p@60Hz 36bpp)The manual states no factory default for this switch, so every install must set it deliberately; NORMAL gives full colour depth for Aigna's typical runs, XTRA trades colour depth for 150m reach on a longer run.source
- VerifyRS-232 extensionFixed at 115200 baud; not adjustableConfirms the connected controller or display is also set to 115200, since the extender can't be changed to match a different rate.source
What the vendor's documents don't say (3)
- No web interface, IP control or DIP-switches are documented for this model, only the one slide switch (plus the paired transmitter's own PROG/NORMAL firmware switch, out of scope here).
- No factory-default position is stated for the NORMAL/XTRA RANGE switch, so it is marked 'change' rather than 'verify'; every install should set it explicitly and record which position was used.
- No current firmware or hardware revision is published.
Provision is the first step of Deploy: before or as each av extender arrives, every system gets its record, so the device is known the moment it is plugged in. It is ticked in the project's Deploy page; this is what each record needs.
Firmware
Not versioned
No version is named for this setup guide.
Licence and management
No licence named in this setup guide.
Managed in: Front-panel DIP switches.
AssetboxAsset register
assets/<asset tag>.json
Needs
- Asset tag
- Serial
- Model
- Space
- Status
Healthy when status is active; space matches where the device is installed.
InfoDNSAddresses and DNSNot used
No record: av extender units are not kept in InfoDNS.
Fleet LensDevice managementNot used
No record: av extender units are not kept in Fleet Lens.
AppStateRoom booking and signage fleetNot used
No record: av extender units are not kept in AppState.
Monitor DogMonitoringNot used
No record: av extender units are not kept in Monitor Dog.
Rear panel › NORMAL/XTRA RANGE slide switch
- SetNORMAL/XTRA RANGE Slide SwitchNORMAL (up to 100m at 1080p@60Hz 36bpp)
Rear panel slide switch › Front panel
- VerifyRS-232 extensionFixed at 115200 baud; not adjustable
Where AG-000278 (3.01 Reception, Dublin office) is recorded in each system, against what Keia Atlas expects. Simulated values.-found +expected
AssetboxAsset registerIn sync
# assets/AG-000278.json asset_tag: AG-000278 serial: DEMO-DUB-000278 model: Kramer TP-580Rxr location: Dublin office, 3.01 Reception status: In service
InfoDNSAddresses and DNSNot used
No record: AV extenders are not kept in InfoDNS.
Fleet LensDevice managementNot used
No record: AV extenders are not kept in Fleet Lens.
DarkSignSignage playersNot used
No record: AV extenders are not kept in DarkSign.
AppStateRoom booking and signage fleetNot used
No record: AV extenders are not kept in AppState.
Monitor DogMonitoringNot used
No record: AV extenders are not kept in Monitor Dog.
Being configured now
In each project's Deploy pageNo project is configuring it now.
Units running it
4 in service · 0 drifted · simulated check| Unit | Space | Office | Model | Status | Records |
|---|---|---|---|---|---|
| Pantry AV extender | 13.15 Pantry | Chicago office | Kramer TP-580Rxr | In service | In sync |
| Reception AV extender | 3.01 Reception | Dublin office | Kramer TP-580Rxr | In service | In sync |
| Welcome lounge AV extender | 5.01 Welcome lounge | Dublin office | Kramer TP-580Rxr | In service | In sync |
| Reception AV extender | 8.01 Reception | Melbourne office | Kramer TP-580Rxr | In service | In sync |