Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Assets is switched off
Device types, units, models, setup guides, standards, IT stores and cables. This demo has the Assets module switched off in Organisation settings.
Setup guideAV extenderStand-aloneSimulated
WP-20CT wall plate
Every unit in use matches itchecked just now
Configuring happens in a project's Deploy page
Each device is provisioned, installed, configured in this setup order and commissioned there, ticked off with who and when. This page is the standard it follows.
No project is configuring it now. Every project
On the units running it
- Units in service
- 4
- Records drifted
- None
A practice run. A new install, in order. Ticks stay on this browser. The real run is ticked device by device in a project's Deploy page.
0 of 6A 1-gang in-wall HDMI/USB-C auto-switcher feeding the space's HDBaseT receiver. Aigna fits the optional 20V supply so the plate can also charge a laptop over USB-C; RS-232 is fixed and not user-adjustable.
PowerRear panel terminal block
- Set12V/20V Power SupplyRear panel › 12V/20V Power Supply 2-pin terminal blockKramer 20V/6A supply (PS-2006-O)The base 12V supply only runs video/USB switching; Aigna fits the 20V supply so the plate can also charge a connected laptop over USB-C PD, up to 60W.source
RS-232Rear panel terminal blocks
- VerifyCONTROL RS-232 port115200 baud, 8 data bits, 1 stop bit, no parity, ASCII commands (fixed)Confirms a room controller talking to the plate itself uses these fixed settings; they can't be changed on the device.source
- VerifyEXTD RS-232 port300-115200 baud, bidirectional extension to the far end (fixed range, auto)Confirms the extended RS-232 line, for example to a display, doesn't need a rate set on this plate.source
What the vendor's documents don't say (3)
- Only the Quick Start Guide could be opened for this model; Kramer's full WP-20CT user manual (checked at the vendor CDN, at manualslib, and via the 'WP Series combined user manuals' PDF) could not be reached, so the embedded web pages' menu names, default IP address, admin password and firmware-update procedure are not documented here.
- No PoE standard (802.3af/at/bt type or class) is stated for the power the plate can accept over the HDBaseT cable from a compatible receiver.
- No DIP-switches are documented on this model; the Quick Start Guide only mentions the terminal blocks and the USB-C-hosted web pages.
Provision is the first step of Deploy: before or as each av extender arrives, every system gets its record, so the device is known the moment it is plugged in. It is ticked in the project's Deploy page; this is what each record needs.
Firmware
Not versioned
No version is named for this setup guide.
Licence and management
No licence named in this setup guide.
Managed in: Device web interface.
AssetboxAsset register
assets/<asset tag>.json
Needs
- Asset tag
- Serial
- Model
- Space
- Status
Healthy when status is active; space matches where the device is installed.
InfoDNSAddresses and DNSNot used
No record: av extender units are not kept in InfoDNS.
Fleet LensDevice managementNot used
No record: av extender units are not kept in Fleet Lens.
AppStateRoom booking and signage fleetNot used
No record: av extender units are not kept in AppState.
Monitor DogMonitoringNot used
No record: av extender units are not kept in Monitor Dog.
Rear panel › 12V/20V Power Supply 2-pin terminal block
- Set12V/20V Power SupplyKramer 20V/6A supply (PS-2006-O)
Rear panel terminal blocks › RS-232
- VerifyCONTROL RS-232 port115200 baud, 8 data bits, 1 stop bit, no parity, ASCII commands (fixed)
- VerifyEXTD RS-232 port300-115200 baud, bidirectional extension to the far end (fixed range, auto)
Where AG-000277 (3.01 Reception, Dublin office) is recorded in each system, against what Keia Atlas expects. Simulated values.-found +expected
AssetboxAsset registerIn sync
# assets/AG-000277.json asset_tag: AG-000277 serial: DEMO-DUB-000277 model: Kramer WP-20CT location: Dublin office, 3.01 Reception status: In service
InfoDNSAddresses and DNSNot used
No record: AV extenders are not kept in InfoDNS.
Fleet LensDevice managementNot used
No record: AV extenders are not kept in Fleet Lens.
DarkSignSignage playersNot used
No record: AV extenders are not kept in DarkSign.
AppStateRoom booking and signage fleetNot used
No record: AV extenders are not kept in AppState.
Monitor DogMonitoringNot used
No record: AV extenders are not kept in Monitor Dog.
Being configured now
In each project's Deploy pageNo project is configuring it now.
Units running it
4 in service · 0 drifted · simulated check| Unit | Space | Office | Model | Status | Records |
|---|---|---|---|---|---|
| Pantry AV extender | 13.15 Pantry | Chicago office | Kramer WP-20CT | In service | In sync |
| Reception AV extender | 3.01 Reception | Dublin office | Kramer WP-20CT | In service | In sync |
| Welcome lounge AV extender | 5.01 Welcome lounge | Dublin office | Kramer WP-20CT | In service | In sync |
| Reception AV extender | 8.01 Reception | Melbourne office | Kramer WP-20CT | In service | In sync |