Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Projects is switched off
Projects, the schedule, planning, the work plan and the Lab. This demo has the Projects module switched off in Organisation settings.
Batch 7 of 8 · Project PRJ-11Simulated live
2 Poly PoE++ 65W 2.5G Adapters
2 units checked, ready to accept · 2 of 2 set upchecked just now
Setup is done by Aigna's engineers. Your installs are on the Deploy page.
Once for all 2
Through On each unitSet on each unit by hand On each unit. Keia Atlas cannot read these back, so a person confirms them.
0 settings to set and 3 to check; 0 left at the manufacturer's default.See every settingThe setup guide
The units
Only what differs per unit. Each unit's build sheet has every setting worked out.Nothing is ready for you here. Keia Atlas keeps checking these units.
| Unit | Provision | Install | Configure | |
|---|---|---|---|---|
| Build sheet | ||||
| Build sheet | ||||
Setup order
Optional: tick as you go, or let the checks do it1Mount or rack the injector near the space's network switch.2/2
2Connect the data-in port to the switch (a standard 2.5Gb/s network port, no PoE required from the switch).2/2
3Connect the data+power-out port to the Poly Studio X32 or V12 using the included 3.66m CAT6A cable.2/2
4Connect the included power cord to mains.2/2
Every setting
3 in the setup guide, as patternsValues marked Per unit are patterns here. Each unit's build sheet has them worked out: 12.04 Wren, 12.05 Robin.
Verification3
- PoE outputCheck it is Up to 65W, 802.3af/at/bt compliant per HP/Poly
Why
Confirms the injector can supply what a Studio X32 or V12 draws, with no configuration needed to reach that budget.
- Included CAT6A cableCheck it is 3.66m, used between the injector and the bar
Why
Confirms the 2.5Gb/s link and PoE both run over the cable Poly supplies in the box, rather than a substitute patch cable.
- Mains power cordCheck it is The included cord, seated fully at both ends
Why
The only power path for the unit; there's no PoE pass-through or DC input to configure instead.