Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Assets is switched off
Device types, units, models, setup guides, standards, IT stores and cables. This demo has the Assets module switched off in Organisation settings.
Setup guideAmplifierStand-aloneSimulated
PA-240Z ceiling speaker amplifier
Every unit in use matches itchecked just now
Configuring happens in a project's Deploy page
Each device is provisioned, installed, configured in this setup order and commissioned there, ticked off with who and when. This page is the standard it follows.
No project is configuring it now. Every project
On the units running it
- Units in service
- 5
- Records drifted
- None
A practice run. A new install, in order. Ticks stay on this browser. The real run is ticked device by device in a project's Deploy page.
0 of 7A half-rack amplifier driving Aigna's 70V/100V ceiling speakers. The output-mode DIP-switches are already at Kramer's Hi-Z/100V default, which matches the speaker taps; the embedded web UI is used to join the AV VLAN, tighten the default password, and set EQ/levels for the space.
Output mode (DIP-switches)Rear panel Hi-Z/Lo-Z and 100V/70V DIP-switches
- VerifyHi-Z/Lo-Z (DIP 1)Rear panel › Hi-Z/Lo-Z and 100V/70V DIP-switches › DIP 1Hi-Z (default)Aigna's Galil 6-C ceiling speakers are wired to the 70V/100V transformer taps, which needs Hi-Z mode; Lo-Z is only for a direct 4/8 ohm pair.source
- Verify70V/100V (DIP 2)Rear panel › Hi-Z/Lo-Z and 100V/70V DIP-switches › DIP 2100V (default)Matches Kramer's own default and the higher-voltage tap on the Galil 6-C, which keeps run current low over longer ceiling cable runs.source
NetworkDevice Settings web page
- VerifyDHCPDevice Settings › Ethernet SettingsOn, with a reservation on the AV VLANAigna's AV devices sit on a DHCP-reserved address on the AV VLAN rather than a hand-typed static one.source
SecuritySecurity > Authentication page
AudioSpeaker Output web page
- SetHigh-Pass FilterOnCuts frequencies below 70Hz that the Galil 6-C isn't rated to reproduce, which saves amplifier headroom for a background-music/voice room.source
- VerifyBass/Mid/Treble EQFlat (0dB), Kramer's defaultLeft flat until a space's acoustics are measured; Aigna doesn't pre-set an EQ curve blind.source
- SetMaster VolumeSet per space during commissioningNo factory default level is stated; it's set to a safe, audible level for each space's speaker count and ceiling height.source
FirmwareDevice Settings web page
- VerifyFirmware update methodManual upload only, no automatic-update toggle existsThere's nothing to turn off; firmware only changes when an installer manually uploads a file, which already matches Aigna's Lab-first policy.source
What the vendor's documents don't say (3)
- The rear-panel master volume trimmer's factory position and the web page's Master Volume slider default are not stated.
- Consumption is given only as 265VA (apparent power), so it isn't possible to size a circuit in watts from the manual alone.
- No current firmware number is published; settings were checked against the manual's own P/N 2900-300802 Rev 6, which is shared with the smaller PA-120Z.
Provision is the first step of Deploy: before or as each amplifier arrives, every system gets its record, so the device is known the moment it is plugged in. It is ticked in the project's Deploy page; this is what each record needs.
Firmware
Not versioned
No version is named for this setup guide.
Licence and management
No licence named in this setup guide.
Managed in: Device web interface.
AssetboxAsset register
assets/<asset tag>.json
Needs
- Asset tag
- Serial
- Model
- Space
- Status
- Hostname
Healthy when status is active; space matches where the device is installed.
InfoDNSAddresses and DNS
zones/aigna.example/<hostname>
Needs
- Hostname
- Mac address
- Ip address
Healthy when address reservation matches the MAC address; forward and reverse DNS records resolve.
Fleet LensDevice managementNot used
No record: amplifier units are not kept in Fleet Lens.
AppStateRoom booking and signage fleetNot used
No record: amplifier units are not kept in AppState.
Monitor DogMonitoringNot used
No record: amplifier units are not kept in Monitor Dog.
Rear panel › Hi-Z/Lo-Z and 100V/70V DIP-switches › DIP 1
- VerifyHi-Z/Lo-Z (DIP 1)Hi-Z (default)
Rear panel › Hi-Z/Lo-Z and 100V/70V DIP-switches › DIP 2
- Verify70V/100V (DIP 2)100V (default)
Device Settings › Ethernet Settings
- VerifyDHCPOn, with a reservation on the AV VLAN
Security > Authentication page › Security
- VerifyActivate SecurityEnabled (default)
- SetWeb pages user name and passwordFrom the password vault, per site
Speaker Output web page › Audio
- SetHigh-Pass FilterOn
- VerifyBass/Mid/Treble EQFlat (0dB), Kramer's default
- SetMaster VolumeSet per space during commissioning
Device Settings web page › Firmware
- VerifyFirmware update methodManual upload only, no automatic-update toggle exists
Where dub-303-amp01 (3.03 Heron, Dublin office) is recorded in each system, against what Keia Atlas expects. Simulated values.-found +expected
AssetboxAsset registerIn sync
# assets/AG-000286.json asset_tag: AG-000286 serial: DEMO-DUB-000286 model: Kramer PA-240Z location: Dublin office, 3.03 Heron status: In service
InfoDNSAddresses and DNSIn sync
# zones/aigna.example/dub-303-amp01 fqdn: dub-303-amp01.aigna.example address: 10.20.3.59 mac: 02:3f:89:df:ba:93 reservation: yes
Fleet LensDevice managementNot used
No record: amplifiers are not kept in Fleet Lens.
DarkSignSignage playersNot used
No record: amplifiers are not kept in DarkSign.
AppStateRoom booking and signage fleetNot used
No record: amplifiers are not kept in AppState.
Monitor DogMonitoringNot used
No record: amplifiers are not kept in Monitor Dog.
Being configured now
In each project's Deploy pageNo project is configuring it now.
Units running it
5 in service · 0 drifted · simulated check| Unit | Space | Office | Model | Status | Records |
|---|---|---|---|---|---|
| Heron amplifierdub-303-amp01 | 3.03 Heron | Dublin office | Kramer PA-240Z | In service | In sync |
| Boardroom amplifierdub-502-amp01 | 5.02 Boardroom | Dublin office | Kramer PA-240Z | In service | In sync |
| Briefing auditorium amplifierdub-504-amp01 | 5.04 Briefing auditorium | Dublin office | Kramer PA-240Z | In service | In sync |
| Heron amplifiernyc-2004-amp01 | 20.04 Heron | New York office | Kramer PA-240Z | In service | In sync |
| Corncrake amplifiernyc-2201-amp01 | 22.01 Corncrake | New York office | Kramer PA-240Z | In service | In sync |