Keia Atlas
Healthy- Space12.08 Barn Owl
- ModelKramer SWT3-31-HU
- SerialDEMO-CHI-000047
- LifecycleIn service
Healthy when recorded in the space its space type expects; every port wired as the space type says.
Viewing as , ,
Vendor access
This part is for Aigna staff
Vendors see their own installation and the device reference they need to build it: device types, setup guides and models. Everything else stays with Aigna.
Go to your installationModule
Assets is switched off
Device types, units, models, setup guides, standards, IT stores and cables. This demo has the Assets module switched off in Organisation settings.
Device typeav-switcherVersion 1.02 models
AV switcher
9 units in service · no advisories to review
190 mm × 27 mm × 116 mm, front, to scale
Every spec and portShowing Kramer SWT3-31-HU
Ports
17 ports, front and rear
- Width
- 190 mm
- Height
- 27 mm
- Depth
- 116 mm
- Weight
- 0.56 kg
- Power
- 84 W max
Drawing traced from Kramer SWT3 user manual, Figure 1 (front panel). Ports from the vendor's documentation.
Checked on one example, chi-12-08-dev01 (simulated values).
Asset register
Healthy- Asset tagAG-000047
- SerialDEMO-CHI-000047
- ModelKramer SWT3-31-HU
- Space12.08 Barn Owl
- StatusActive
Healthy when status is active; space matches where the device is installed.
What each field means, and how hostnames and addresses are built: Learn: device fields
AV switcher·v1.0·19 Oct 2026
SWT3-31-HU room switcher
- ModelSWT3-31-HU
- FirmwareNot versioned
- ModeStand-alone
Checkingon AG-000340
Settings
9 set · 11 verify · 3 per device
New install, in order
- 1Patch into the space's AV port and power on; the device auto-acquires an address (DHCP) or falls back to 192.168.1.39.
- 2Browse to the device's IP, sign in with the default Admin/Admin credentials, and change the password immediately.
- 3Set the device name and confirm the network settings below.
- 4Set the auto-switching policy and USB routing mode for the space.
Setup guide file state
- AssetboxIn sync
Open the setup guideConfiguring happens in a project's Deploy page.
No firmware line tracked for Kramer SWT3-31-HU
When the vendor watcher tracks a model, its releases, Aigna's decision on each, and any advisories appear here and on every device of that model.
Symptoms
Likely causes and where to look firstWrong source shownAuto-switching picked another input; Source cable faultCheck Keia Atlas first
Cross-checks
The same fact must agree everywhere it is recorded| Check | Compares |
|---|---|
| Serial match | keia_atlas.serial = inventory.serial |
| Space match | keia_atlas.space = inventory.space |
Used in
Device type file
- File
- data/device-classes/av-switcher.yaml
- Version
- 1.0
- Updated
- 2026-09-27
- Hostname prefix